PDA

View Full Version : Dumb Newb questions

bobsj
03-01-2008, 07:27 AM
Hi all;

I have a rom 102 that I think I screwed up. I tried to load a good bin on it and somehow locked myself out of the card.

N2edit says it's a bad image when it tries to read it. If I run rebel with winexp it gives an error t4 right after identifying the type of card i have.

I have another program called ftapirate that will glitch into the card and my unlock lights light up (both of them) Now what? I tried to put a new program down to it with n2 and still have the same problem, it won't write.

I can glitch into it again in about 4 min with ftapirate. Any suggestions would be much apprecaited on how I can save this 102..


Thank You,

Bob
fubr
03-01-2008, 08:11 AM
if fta pirate will let you glitch back into it then write a clean valid rom 102 image to it, use a rev 103 image.
that should do it
bobsj
03-01-2008, 08:20 AM
HI fubr;

Thank You for your reply. What program would I use to write back to it? I can glitch in, but if I load n2edit or anything else and try to write I get an error and my 2nd light on my unlocker goes out.
hacker
03-01-2008, 08:26 AM
HI fubr;

Thank You for your reply. What program would I use to write back to it? I can glitch in, but if I load n2edit or anything else and try to write I get an error and my 2nd light on my unlocker goes out.Try nagramaster with your unlocker. I think it needs to be flashed to NEWD 13 or something like that.
fubr
03-01-2008, 08:36 AM
no ISO??

if you got an iso use n2edit and nagraedit52 to write
bobsj
03-01-2008, 08:50 AM
I do have an iso, but after ftapirate glitches me in, I put the card into iso and it will not write to it still. It will not write to it using the ulocker either. Anymore more suggestions much appreciated..

Thank You
hacker
03-01-2008, 08:56 AM
Did you try to force write it in nagramaster with the unlocker? That saved me a few times in the past.
Wiley-X
03-01-2008, 06:19 PM
This is just a prime example why you should NOT use a loader/unlocker to write a bin to a card!

You wouldn't use a screwdriver to drive a nail would you??? Use the proper tool for the job!!!

You should ALWAYS use an ISO reader/writer to do the writing!

~Wiley~