Think Card Fubared Help

[teknikal]

Ok so I hardly ever post unless have an issue. do mostly reading, Here is my issue, Unlocked card read eeprom edited the keys then i added the relock
$3176801AFB900801A8000
$980E20687
Wrote back to card then I tried to read and it gave me an error could not read not the normal Backdoor is not present error, said failed reading back door now I can not get back in it. It says that it is rom102 rev 10C
any suggestions I have tried romexplorer to force write a clean image and it says error writing on line 3080 do you want to force write may work if partial interceptor is installed. Looks like it is working but reset cad and still REV10C
any Ideas
thanks

[Crazy1_79]

might have to glitch back into it. do you mean nagramaster force write? try it with iso and loader if you have both. i have had better luck with loader though. it has saved my ass a time or two. then if that don't work. there is a password sender progrma that may get it. and if all else fails. fire up the rm1a unlocking program and glitch back in. cross your fingers though!!

[teknikal]

Tried RMa1 and get error improper Cmd22 response unable to continue any ideas what this means?

[skinerd]

Tried RMa1 and get error improper Cmd22 response unable to continue any ideas what this means?

Bad Cmd 22 usually means RM1a is trying to open a spoofed cam. Not the real revision, so it errors. For exapmle a spoofed 10c will not return same codes as a real stream locked 10c..

[teknikal]

I see this one is not streamed locked, I believe it is unknown provider now, does the loader need the 4619 chips to work with the newer scripts that are out? I have a older one that does not have these chips.