unlocking 102 10b

[jsa71]

I'm trying to unlock my card using rm_1c but all I get is a glitching error box that pops up. I'm using the how to guide that's found on this site but not having any luck. When I flashed my blue nexus, I could not go into the show timing area so I'm not sure if that has anything to do with it or not. If there is a better unlocking script or different method, please help. I am a newbie but I've tried to learn as much as possible but this is very frustrating. Is there a better how to guide out there that I could use?

[Wiley-X]

What hex file did you flash to your Nexus?? To use RM-1C, you need to have the RSX1 flashed to your unlocker (Nexus). Depending on what package you downloaded, sometimes the RSX1 doesn't come in the package...

[chep]

What error are you getting?

[jsa71]

I used xpatmel to flash but could not get the" show timing box" to come up. So you are suggesting that I re-flash with rsx1 and try it from there

[jsa71]

I also don't see the rsx1 file on this site, where can I find it

[jsa71]

when I tried running it with the atmel flash I get "could not find active atmel" message, any idea

[chep]

you have to have BOTH flashes in the folder. All flashers need the eprom flash and its matching flash also. You need the rsx1flash and eprom flash.

[gizmolite]

delete the file you have for RM_1C and xpatmel download the ones found on this site...http://bellexpress.vu/forum/local_links.php?catid=25 these files have all the correct information in then....

[pcpartsrus2001]

what kind of loader you got? the not finding active atmel message usually means you dont have the loader ready to flash, a jumper needs to be in place or like the nexus you need dip 1 and 6 on I think it is.

[jsa71]

I have ohms set 2.2 should I lower ohms setting, using the nexus blue

[pcpartsrus2001]

first did you get the loader flashed with rsx1? lets not jump to far ahead, need to make sure loader is flashed correctly first

[jsa71]

yes loader is flashed withrsx1

[jsa71]

the flash seems to be correct but still get glitching error message

[pcpartsrus2001]

Ok, do you have the dips in correct posistion? I believe on yours its 2 and 5 on I believe if you do some searching in the forums there are a few decent settings for unlocking for your loader, I think around 220 ohms is where most were popping them but not for sure, need to do a bit of searching to make sure.

[jsa71]

flashing is pins 1 & 6 on and 2 & 5 for prgramming. I think 2.2 is the same as 220 just depends on how you have the multi set

[AOAOAO]

Try what I posted in the pic to flash your loader. You may also try Rebelsurf's 109/247 unlocker flashed with NewdRS. Good Luck!

[jsa71]

Thanks, now at least I am getting .................................................. ........ but nothing else, maybe I should try to turn down the ohms. I just don't want to loop my card

[pcpartsrus2001]

I would let it run at that, I use a mikobu vortex pro and all I ever see is .......... till it pops, if you go to low on ohms it will most likely loop, just let it run

[jsa71]

cool, thanks

[AOAOAO]

....................... is correct, let it run.

[Wiley-X]

Your dots may also change to dashes after about an hour...this is normal....let it run until it pops.