mili's Nexus and 102 rev 109

[noone]

Hi

I have this 109 stream locked and want to pop it.

I am using mili's white nexus (as the site says: "used to be blue nexus")

any advice on what is the best script for this rev. and what are the settings? ohms, dip switches, flash for the atmel?


thanks in advance.

[Wiley-X]

Use RM-1A, start at 200 ohms, don't go below 100 ohms. Use the included RSX-1 hex to flash to the loader (RM-1A will not run without it).

[noone]

thanks for the reply

what dip switches, I read 2 and 5 down, is that right or I missed something?

also, while searching, I read about RM-1C, and rebelsurf. how they are compared to RM-1A? isn't the 1C later, or it is for different revisions?

I also read somewhere that it is better not to try the 109 and stream it to a later revision, like 10C. but I don't have the receiver that the card married to, and my receiver says this card is not valid for this receiver.


sorry to bother you with so many questions, but I have no experience in this field, both the loader and the card were given to me by a friend.

[PRCHOICE]

Check to see what chip you have in it. You may want to change it for higher revs

[Crazy1_79]

it has 4619's in it. i would use rm1_c and use dips 2 and 5 down. i have made quick work of a couple of high revs with it. both popped in 30 minutes or less. I set my ohms at 700 which is high comparied to most people. be sure to set ohms with no cable or power supply hooked up to it.

[noone]

thanks all

yes it has the 4619 in it, and yesterday I modded it with the diod which was not in it originally..

I will give it a try tonight and report back.