Problem flashing Mikobu Vortex Pro

[zajebiscie]

i'm Using Mikobu Vortex Pro. And i am having problem flashing my program..Please, dose anyone know how to solve this problem.?

if i try to Analyze it

Working ...
... scanning ...
... scanning ...
... scanning ...
... scanning ...
... scanning ...
... scanning ...
... scanning ...
... scanning ...
... scanning ...
... scanning ...
Unable to locate any functional delay
time for your loader. Make sure
it is plugged in, has the right switches
set, and has been power-cycled before
attempting to use this tool.


AND IF I WANT TO FLASH NewdRS , i will get the following Error.

Hex Files Loaded.
Initializing ...
Initialized
Syncing ...
Synchronized
Vendor Code: 1e (Atmel)
Part Family: 00 Unknown
Issuing Chip Erase ...
Erased
Vendor Code: ff (Unknown)
Part Family: ff Unknown
Programming EEPROM ...
Programming Flash ...
Verifying EEPROM ...
Error verifying EEPROM: Addr 0010,
expected 41, found ff
Stopped on failure
Complete!

PLEASE I NEED YOU GUYS HELP>>>>>thanks

[DISH_DUDE]

Sounds like you bought one oif those Ebay junkers......
Just keep trying over and over it will go sooner or later my friend had the same problem...

[muleman]

open prorgam and click in the center light br and click on set timeing and change 6 to 1 and it will work

[zajebiscie]

i tried everything and i am still having the same problem. Any help will be appricated....thanks

[rg6a]

i tried everything and i am still having the same problem. Any help will be appricated....thanks

If you've thrown everything at it, timing, delays, com ports, switch settings, cables, different computer and still nothing works........it could be the Atmel.

Like what do they go for these days, $6-8? Try a new one.


PS just thought of something, not familiar with that model but it could be a bad cap or support TTL. Try reading and writing to an old HU, if it works then I'd say the Atmel is faulty and there was a bad run of them that ended up at discount electronic dealers that weren't authorized Atmel resellers.

PPS just had a 3rd thought, if you're running XP SPx.....do you have a Real Dos diskette laying around.....if so make a boot disk with your flash software and file and Boot off that and try again.....just a thought.


Good Luck and let us know how it went.

[lump72]

try the program ,,, UFP 1.6 , i use it on my vortex pro with no problems ,.

[zajebiscie]

where can i get UFP 1.6 and could explain how it works....>/?