st19xl 2.7.09

[nwbee]

hxxp://rapidshare.com/files/129030722/st19xl-2.7.09.zip. I have it working flawless with last ultra aux. Awsome job pgm. I think that it might not need an aux but havent tested it without ultra aux

[JT]

Can also be found here

http://bellexpress.vu/forum/local_links.php?catid=64

[flag]

WOO HOOO!..thanks pgm

[OverEasy]

THANKS PGM... It works without aux software or card. Sweet ! !

[hughnohoo]

could someone who is running this cardless and no ultra aux be kind enough to post your cmd line ? All I get is constant resets and have run out of stuff to stick in the cmd line..but cemu works GREAT !

[pecker88]

could someone who is running this cardless and no ultra aux be kind enough to post your cmd line ? All I get is constant resets and have run out of stuff to stick in the cmd line..but cemu works GREAT !

Assuming emu board is connected to COM1:
st19xl.exe /m

Assuming emu board is connected to COM2:
st19xl.exe /m /pe2

Assuming emu board is connected to COM3:
st19xl.exe /m /pe3

you get the drift....

[hughnohoo]

thanks pecker, but I got it...just had to ignore the scrolling resets when I started it and damned if it didnt work:
st19.exe -s -m -o -PE1 st.cor

woo hoo !

[bj62]

What is currently working for BEV? All I get is red guide. I was working earlier today.

[JT]

I know about one receiver that would give error 20 almost every time until snooping was disabled. (the -s) in the .bat file. It was a 301.13 at firmware P450.