Need a refresher on NORSA for a 301.10

[Greystone]

My 4900 died.

I replaced it with a 301.10.

I backed up the TSOP in Flashedit.

I forget what I need to do to use NORSA mod and public numbers?

Build EAFJ

Do I virginize?
Do I FIX CRC?
It asks for 2 Bins?

Thanks in advance.

[JT]

Easiest way to go is to just download some pre-made tsops from the tsop bank and write them to your box. If the tsop image doesn't come with an eprom image, then use flash edit to make a virgin eprom image from the pre-made tsop image. Not much more to it than that. Double check the green highlight with the CRC and do that if you need to, but that will probably already be done. The 301.10/3100 has two 2Mb tsop images. (U22 and U23) This particular box is highly flexible in terms of build versions it will accept. It will take every build AFAIK. EAEA is the most common. EAFA is no problem either, and I think I uploaded the NoRSA EAFA images to the tsop bank myself.

[Greystone]

So when I go to flash do I do a full flash using either u22 or u23 or do I need to do them seperately, and if so what sectors?

Cheers

[JT]

Erase flash U23 a few times, then write NoRSA U23, then erase U22 a few times, and write NoRSA U22, then write virgin eprom to match. Don't know if you downloaded the versions I uploaded or not, but shouldn't be a problem as a lot of folks have circulated NoRSA images. They're not that hard to create. (EAFJ is the same build as EAFA, the last letter is assigned an A by flash edit)

[Greystone]

Thanks JT, much appreciated Iwill d/l yours and giver her a go.

So when I erase I do a full erase and full write once each for U22 and U23? Or is there a sperate sector for each, that is where I seem to be messsed up.


Sorry JT could you point me to your upload. They all say uploaded by anonymous?