dish 1000.2

[ptdume]

When using a DPP 1000.2 LNFB, do you have to use the DPP44 switch, to to hook up the RG-6 cables from 110, 119 and 129 to the receiver? How do you get the three exiting cables into one, can this done with or without a separater ? Finally can the 1000.2 support two receivers, ie. 301.010 and a VIP ?

[studmonkey76]

if ur using the 1000.2 pro lnb, then u dont need 3 cables...it has a built in switch....it has 3 outs and 1 in....use one of the outs for 1 room and use another out for another room...the lnb can support 3 rooms(3 recievers)

[ptdume]

so the the 3 ports next to the lnb port can go to three receivers, where does the lnb port hook up to, sorry for this brain freeze overload, thanks....

[calibx77]

The 3 connectors are EACH able to carry all 3 orbital locations 110, 119.129 , because as the previous poster has already said, the are the output of an internal switch. The other connector is marked "in" and that can be used for input from a second dish if you have one. So all you need to do is run an RG6 cable from any of the 3 LNB connectors to a receiver.

[ptdume]

calibx and stud thankyou for your info, much appreciated....