New to unlocking anyting above 105.

[zerocool]

Hi, first time I'm tring to unlock anything above 105 (did those with orange nexus) and now just got myself a powersync.

Been trying all day with rommaster v1c using powersync, with switch 1 on and everthing else off. Pot set to 200ohm as recommended in another post and nothing.

I've got a rev107 trying now and rev109 (haven't tried to unlock yet).

Any advice?

[puppycake]

Hi, first time I'm tring to unlock anything above 105 (did those with orange nexus) and now just got myself a powersync.

Been trying all day with rommaster v1c using powersync, with switch 1 on and everthing else off. Pot set to 200ohm as recommended in another post and nothing.

I've got a rev107 trying now and rev109 (haven't tried to unlock yet).

Any advice?
There are some that are cranky to pop and every unlocker I ever used on the 102's seemed to have a different ohm setting for the sweet spot.
Make sure you flashed your powersync with the proper flash for that script(rsx1).
when I get one that wont pop with the setting I normally use I run it for about 1hour then stop and increase/decrease ohms about 3or4 at a time.Make sure to take the reading with the power off and no card in the unlocker.Be patient it will pop sooner or later.(or loop) Good Luck!!:)

[dbelectric]

I use 220 ohms with power sync switch 1 only
.................................................. ...................
.................................................. ...................
.................................................. ...................
........................................ !!!!!!!
******* Good response received! *********
55
===========================================
55 was hit at: Delay:00AE VCC:0019 GlitchType:B0/07
Timeout Factor:04
Elapsed: 00:01:02
VCC Resolution: 0.0625
Delay Range: 00AE to 00CE
********************************
* Rom102, Rev10B CAM OPEN! *
* PROCEED AS NORMAL *
* GOOD LUCK! :-) *
********************************
....
........ !!!!!!!
******* Good response received! *********
55
===========================================
55 was hit at: Delay:00B1 VCC:000D GlitchType:B0/07
Timeout Factor:03
Elapsed: 00:09:05
VCC Resolution: 0.0625
Delay Range: 00AE to 00CE
********************************
* Rom102, Rev10B CAM OPEN! *
* PROCEED AS NORMAL *
* GOOD LUCK! :-) *
********************************