panchocuerdas
04-15-2009, 11:26 PM
Well I run drivers 1 and 2 of the new software (1.09) and now my slinger program is not responding I have a vostro with XP and all updates??
What could be the problem?
When I hook the slinger with the USB connector and click on read or write it freeze (not responding)
I try to correct the issue by uninstalling the Netframework program and installing it again, also the drivers installed for the slinger.
The story is that I unintalled the drivers and installed them again but still the same problem when I open the slinger program everything is ok but as soon as I perform a write or read then it freezes and no response..
New development!!!
If I open a second program (slinger ) in the top of the one that is frozen then I can read and program my slinger without any problem?? Then I cannot close or do nothing with the frozen Slinger program that I opened first, not even with the Task Manager End Task instruction??
What could be the problem?
Any suggestion will be very wellcome
What could be the problem?
When I hook the slinger with the USB connector and click on read or write it freeze (not responding)
I try to correct the issue by uninstalling the Netframework program and installing it again, also the drivers installed for the slinger.
The story is that I unintalled the drivers and installed them again but still the same problem when I open the slinger program everything is ok but as soon as I perform a write or read then it freezes and no response..
New development!!!
If I open a second program (slinger ) in the top of the one that is frozen then I can read and program my slinger without any problem?? Then I cannot close or do nothing with the frozen Slinger program that I opened first, not even with the Task Manager End Task instruction??
What could be the problem?
Any suggestion will be very wellcome