norton
05-10-2009, 01:02 AM
I am getting CRC errors with the new cemu 2.13f. I usually run ST19XL, but am trying out cemu since st is down. ( I never have much luck with cemu, never wants to run for very long for me)
Cemu runs for a while then spits out:
@@@@@@@@@@@ CRC error when reading com port @@@@@@@@@@@@@@@@@@
Was 0x21 Correct 0xCD
then the picture goes black, sometimes throws Invalid Smartcard for this receiver
Just wondering if anyone has seen this? First thought is the solder connections on my emu cable, but I have no problems with ST19XL with this setup. Maybe ST is more tolerant of errors? Going to try to touch up the solder connections and see if that helps
Cemu runs for a while then spits out:
@@@@@@@@@@@ CRC error when reading com port @@@@@@@@@@@@@@@@@@
Was 0x21 Correct 0xCD
then the picture goes black, sometimes throws Invalid Smartcard for this receiver
Just wondering if anyone has seen this? First thought is the solder connections on my emu cable, but I have no problems with ST19XL with this setup. Maybe ST is more tolerant of errors? Going to try to touch up the solder connections and see if that helps