st19 working on rom 103 ird

[secondary]

Can anyone confirm if they have st19 version 2.8.22 working on a rom103 based ird. My 942 setup hasn't worked for about a week with all the changes. :cool:

[pecker88]

Can anyone confirm if they have st19 version 2.8.22 working on a rom103 based ird. My 942 setup hasn't worked for about a week with all the changes. :cool:

working flawless. I can assure you that the prob. lies somewhere on your setup. I have had max chips on max/mel go bad several times. Wouldnt' work until I replaced max chip.

What are some probs, b more specific, maybe can help

[secondary]

Just blank screen like keys wont roll, but it does cus I checked the cor file after saving it. On a 942 it never has a 005 error when keys don't match just a blank screen just the way they are. As i watch the communications go by all looks good. I've redone my cor file twice by cleaning in Nedit with no intercept, adding tiers then patching 38c patch. Never had a atmel go bad suppose I could try to reflash it or try another atmel. Oh I'm using a real aux card for aux communications.

[pecker88]

Just blank screen like keys wont roll, but it does cus I checked the cor file after saving it. On a 942 it never has a 005 error when keys don't match just a blank screen just the way they are. As i watch the communications go by all looks good. I've redone my cor file twice by cleaning in Nedit with no intercept, adding tiers then patching 38c patch. Never had a atmel go bad suppose I could try to reflash it or try another atmel. Oh I'm using a real aux card for aux communications.

OK, if communication looks normal, Atmel and max are OK. NO need to reflash atmel, ect...

The problem lies in these possible places:

1. ST19 NOT communicating properly with aux
-at startup of st19, does it say, "Aux card Detected: Perk 1.23"

2. .cor file. Are your tiers and ird info up to date? May need to update your DT-01, (ird info) and DT-07, (tiers) to future date, I'm currently using 1916 = Aug. 1st.

3. .cor file. Make sure your using REAL rev38C codespace. Even after you re-create the .cor with new tiers, and codespace patch, it may take st19 20-30 minutes to update the .cor with current MECM and keys...so just be patient. After 20-30 mins, try chaning the channel, video might then appear.

good luck

[secondary]

do you have the real 38c code space patch? I'm using an arm38c patch not sure if its the right one.

[secondary]

Found out my cor was messed up. I used the wrong 38c codespace to make up my cor. I found just a straight up 38c codespace patch before I used one labeled Arm38c codespace. Should have known, Thanks.