Reviving AVR3

[mbrewer]

Attempting to begin using an AVR3 again. Have used Jeepers and receive guide and channel banner but receiving blank screen on every channel except freebies. Since it has been quite a while since I have used this-what am I missing?

[tight]

check to make sure all you're info for the receiver and card are correct usualy some number is in the wrong place you're you might have to clean the avr a few times i clean them about five times it seems to help.

[mbrewer]

Thanks for your reply. Cleaning AVR?

[tight]

please keep me informed to how you make out.

[mbrewer]

Thanks again for your reply. I don't know what you mean by cleaning my AVR. As far as I can tell all my receiver and boxkeys are entered correctly.

[tight]

in jeepers when you click on atmel at the bottom it says erase flash/eeprom due this about 5 times. sorry about that .

[OneHwyMan]

if you get your freebies,your info is correct.If it is not you get nothing to happen.Its your program that you are using.
Are you using a subbed card?

OHM