PDA

View Full Version : Stupid 2700 Ird And Jtag

montrealgreek
11-26-2003, 04:44 AM
Ok I Tried Everything To Reflash Or Earse My Sa5 But Nothing Happens... I Kee On Getting Error With The Pop Up Saying Power Ird (unplug,,,, I Do Just That And Still Cant Get It To Read Or Right...

I Tried Grounding Pad 1 Lol I Dont Know Where That Is So Can You Please Help Me Out Here...
Thank You
Montrealgreek
Darnat
11-26-2003, 12:59 PM
Open jkeys,flash programming
select SA5 in dropdown
erase..
enter ird into stream...should be simple ...unless...you have erased your tsop!
11-26-2003, 08:34 PM
Chapster99
11-26-2003, 08:41 PM
Errrr.....2700 is definately SA5. Also, I have never needed to ground pad1 on 2700's.

FLASH ADDRESSES TO ERASE
2700 = location SA5 (512 k tsop)
2800 = location SA5 (512 k tsop)
3700 = location SA5 (512 k tsop)
3800 = location SA30 (2 meg tsop)
3900 = location SA30 (2 meg tsop)
4700 = location SA30 (2 meg tsop)
4900 = location SA30 (2 meg tsop)
301.010 = location SA 3 **(flash 1)
301.013 = location SA15 **(flash 2)
501/5100 = location SA54 **(flash 2)
5800 = Location SA54 **(flash2)
6000 = location SA30 **(flash 1)
Darnat
11-26-2003, 10:25 PM
You should also be eraseing SA3 not SA5 (I am pretty sure this is correct, I had software version 255 on a 2700c and now it's 355).

Pauls SA3 is for 3100 ird's!
montrealgreek
11-26-2003, 11:29 PM
where is the pad 1 that i have to ground... when i go to jtag it gives me ird uknown....
11-27-2003, 10:44 PM
Darnat
11-28-2003, 01:08 AM
when it says to power of to flash program dont just continue do not shut off ird untill fine

DoEXACTLY as it says!
Don't worry if you follow the instructions all will be good!
11-28-2003, 01:22 AM
11-28-2003, 01:36 AM
montrealgreek
11-29-2003, 08:51 AM
Greek, does your j-tag have pogo pins and magnets?
Are you holding it compressed to the ird?
On a 2700 the grd pad is the long strip, and 3 pins grd.
YES CROW MY JTAG HAS POGO PINS... AND I AM PRESSING DOWN VERY FIRMLY, THATS NOT THE PROBLEM...

THE PROBLEM IS THAT WHERE IS PAD 1 SO I CAN GROUND IT ....
pyle
12-01-2003, 05:57 PM
pad 1 is the one furthest left with the ird facing towards you. if it works make sure you remove it when you are done.