Two 2700's How to Set Remote ID

[petesapie]

I have two 2700's one on Bev the other on Dish, they are both stacked on top each other. One on ch 3 O/P the other on ch 4 O/P then combined and sent all over the house. How do I get the Bev system to ignore the Remote commands sent to the Dish receiver? Can I change the Remote control ID's. I never had this problem when using different Boxes (Sony & Bev).

[Resitol]

I have two 2700's one on Bev the other on Dish, they are both stacked on top each other. One on ch 3 O/P the other on ch 4 O/P then combined and sent all over the house. How do I get the Bev system to ignore the Remote commands sent to the Dish receiver? Can I change the Remote control ID's. I never had this problem when using different Boxes (Sony & Bev).

First pull your card and check the System Info screen. Near the bottom is the remote address that the receiver is currently set to.
Presently your remote is (obviously) set to this number. Usually "1".
To change the setting first change the remote by pressing and holding the top "Sat" button for about 4 seconds until all the buttons start blinking. Next press the NEW desired code number, like "4". Then press the pound (#) key, at the bottom. If you have done it correctly then the sat button will blink 2 or 3 times.
Now getting back to your receiver, aim the remote at the receiver and press the "Record" (red) button. The number should change on that system info screen to this new setting of "4", done.

If you only have one remote I find it a pain in the buttox to switch it back and forth between codes. Best to have two remotes set diffrently.

Also
Check out the all-new Remote Control Help Channel, channel 101 on DxxH Network! Learn the basics of the remote control, how to program it to operate a TV or VCR, how to set up Locks, Favorite Lists - and more!

[petesapie]

Thanks appreciate the help!