[revial]

Using a 232a/2313 emu with yvous for DISH and getting 019 (smart card error). Everytime I attempt to start it up (comes up after a few moments of loading stuff from satellite). The system I am using is a 3100 converted using stream to DISH.

Firmware is P225 on a dp-301 and I understand that the 301 on DISH has anti-AVR code. and the pin shorting method doesn't seem to work. But then again I don't know how long to short it for or when. Info was a bit sketchy where ever I found it.

Can anyone give me the proper method to gettnig around the anti-avr on this receiver without using a Capacitor (don't have a 1000 uF cap on hand to pop in there) ??

Or anything else I can do for that matter ??

I understand the Anti-avr software was just that > for an avr . You are using a max mel which has eliminated that problem with a 3100. I speak of bell emulation with a 3100 . Not sure if something is different with dish . They are the same IRD so I suspect my statements are accurate .

[revial]

well, I had a few issues apart from anti avr code. Managed to build a working 232a/2313 using alternate vcc source @ cap position and got it running on BEV at EV91. Have not attempted the DISH sat since

Originally Posted by revial

well, I had a few issues apart from anti avr code. Managed to build a working 232a/2313 using alternate vcc source @ cap position and got it running on BEV at EV91. Have not attempted the DISH sat since

Hi, I have a 232/2313 emu also with a dp301 receiver and dish firmware. Do you still have a copy of your BEV firmware, as I want to flash this dp301/3100 to BEV firmware. Or can you steer me in the right direction. Thanks

[revial]

point dish to bev 91, erase SA3 if its a 301.010 using JTAG and Jkeys, let the system update from satellite. (Do without your card/avr/emu in the receiver... then after update use jkeys and jtag and backup a copy of the flash.

For other receivers like the 301.013, there are different ones. Seek and ye shall find

Originally Posted by revial

point dish to bev 91, erase SA3 if its a 301.010 using JTAG and Jkeys, let the system update from satellite. (Do without your card/avr/emu in the receiver... then after update use jkeys and jtag and backup a copy of the flash.

For other receivers like the 301.013, there are different ones. Seek and ye shall find

Yes, I have the 301.013 with the single tsop. I was reading a thread where they said erase SA49, does it sound right??? As I find alot of conflicting info on this receiver. Probably becuase of the 2 versions of it.