[FreshManDTV]

I had the same problem with Yvous as well. The most likely problem for keep getting reset is the connection between the board and the PC. Check your cable maybe too long. Keep it short and see how it goes. I donot use Yvous right now but cemu and seems to work pretty well.

[pepper_95135]

I did think that maybe my cable was too long, so I shortened it from ~20ft to 3 ft. Same result.

Well I think I might have figured out my problem. After looking at everything else, I took another look at my 2313 atmel. The intructions from m24c.net said to use a 2313-10pi ... I had pulled the 2313-4pc from my old HU unlooper. After reading some specs, I realize that the 2313-4pc runs at 4MHz while the 2313-10PI runs at 10MHz. Also, someone else had mentioned that the IRD runs at 4.5MHz. So could my problem be that my atmel is too slow???


This might make sense why I am getting the constant resets.

I feel really stupid now for not noticing this sooner. I will buy a 2313-10pi chip tomorrow, but does anyone with the know confirm that this could be my problem?

Pepper

[FreshManDTV]

Not many ppl doing emu so we get very few attention here :-). Why not try cemu? I haven't tried yvous since last week bc cemu works great with the same setup and everything.

[AWDriven]

I would say that you need the 10 Mhz Atmel for the Atmel program to work correctly. I used Cemu from here with my 1489 modded Atmel emulator, and it worked fine.

AWDriven.