Hi guys... Well, I was about 95% done with my SATEMU internal EMU board when I accidently dropped my meter lead onto the board and smoked the BIG capacitor just to the left (facing CAM slot) of the cam slot. Location number C5010, and also took out the diode which burned up by the flame from the cap. The diode is in location R5006. Also, the transistor that most of use for the 5 volts was what I shorted my lead to ground. That is toast as well. Location HS5001. Since the diode and transistor are torched. I can't see their values or type. Can someone write them down for me in this reply? I would greatly appreciate it. I want top try and ressurect this board. Everything else looks good. Once I replace these parts I will fire it up (no pun) and see if everthing else is good.
If anyone knows where I can get schematics for this, that would be even better. I would appreciate it!!

Going to need more info as to which -013 you are talking about. Need to know if 1 or 2 tsop and build config, otherwise the info you get could very likely be wrong.

013, single TSOP... I think these parts are the same on both single and dual TSOP's right?

Anyways,. any help would be greatly appreciated!!!

Thanks!

C5010 is a 200V, 330 uF, 2288(M) capacitor.

R5006 is a 47 Mohms, +/-5% resistor.

HS5001 is a ST VIPer100 342234

The above is on a DAID build 1 tsop 301-13.

Thanks!!

So that resistor is 47 Meg ohms????

Someone else, on another site said it was a 47 ohm resistor... I wish I could see my old one, but it is smoked to all hell.
Thanks for your help!!!

Yeah it's 47 ohm after looking again. Must be getting color blind...lmao.

Bands are yellow, violet, black, and gold.

Thought the black was blue the first time I looked...sorry my bad.