what model IRD is it ???
has it been modified ???

1. remove card
2. push and hold channel up and channel down (on IRD not remote)
3. when color bars appear on the screen push and hold the power button (while still holding down channel up and channel down) until IRD powers off (about 5 sec.)
4. power IRD on and insert valid card

hope this works
I have 4 222's and never have problems with them

For ordering information, please call customer service, ext. 745

What it means: This Message can mean a few things.

In a Straight Access Card to Receiver setup this message alone can mean that the Card has Failed the IRD's ZKT Test because the ZKT is not Valid for Said CAMiD on the Card. If you got some other message (see Your Access Card is no longer Valid, Please insert you new Access Card) Followed by ext 745 upon reinsertion of card into IRD, then it is almost certain that your CAMiD# has been Blacklisted.

This can also occur if you take out a Non Blacklisted Access Card to clean or whatever and reinsert it without resetting or rebooting your IRD.


What to do: Turn off the receiver and then unplug it from the outlet or power strip. Wait 15 seconds, then plug your receiver back in and turn it on. If the message appears again when you reconnect the receiver, Apply a new Valid bin/image to your card. .

If a Blacklisted bin/cor is your problem, then you are going to need to get a Non Blacklisted bin to apply to your card or Floppy Disk.

[mili]

KHJ blame Mdeven about your name buddy, I did not have a hand in it (but Mark had a hand on it)
mili

well hell Mili you know good ol' Mark lends a hand when ever it is needed