I have got a few settings to work with, not sure exactly which would be best.

I ran testglitch on a clean rom3 loaded with the testglitch.bin...here were my results

Powerunlockverall2 results
===========================================
VCC = &h5B
glitch type = &h07
glitch delay = &h10A3
GLITCHED past 0C BUG!!!, unlocker is good to go.
use the above settings on real unlocker script
3FFF9500
===========================================
===========================================
VCC = &h5F
glitch type = &h07
glitch delay = &h10A7
GLITCHED past 0C BUG!!!, unlocker is good to go.
use the above settings on real unlocker script
3FFF9500
===========================================

Question 1) On the testglitch results where exactly do I put this info on the script?
meaning:
DelayStart =
DelayLimit =
VCCStart =
VCCLimit =

from what I have read I am to put the "vcc=results" for "VCCStart=results". Where do I put the "glitch delay" and "glitch type", or do I leave these alone and not need these settings just the "VCC=results" for "VCCStart=results"?

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~


OK now below is results by doing a D9 glitch and analyzing in same script the vcc ceiling and foor on some locked cards. I know which goes to which card as I put on the card the results.

vcc ceiling=2b
vcc floor=1F

vcc ceiling=2a
vcc floor=1F

Question 2) As I was successfull in opening 4 rom 3's by using these results, I still have 3 more and they don't seem to want to unlock. I was wondering in someones opinion that has success at unlocking rom3's should I use the "testglitch reults above" or am I wasting my time and stick with the ceiling and floor settings from the perspective locked cards gave?

.

[Cid6.7]

I would run the analyzer on the locked rom's with D8/9.Then use the setting's it gives you in unlockrom3.xvb or powersync..

Each card will unlock with different setting's so the testglitch results will only give you the best setting's for the good card you used it on

Ok, so really doing the whole testglitch or analyze on a good card with the testglitch.bin is really a waste of ones time. I wondered why one would get settings for a good card to open a locked card and a completely different card at that.

OK thanks cid6 I will stick with whats been working. I just thought maybe there was a quicker way to get in these locked cards with the results from a good card. These other cards are a bit tuffer than my first ones, I am just gonna have to be patient. I was told they can take up to or more of 4 hours. I have only allowed them an hour maybe 2 then getting antsy and thinking it ain't working. PATIENCE is the key here as I know I am doing the right things cause I have been successfull at unlocking these.

.

cid u da best man
I just pope my rom 3 rev 383
cid what should I do next now I have this card poped