[mongoose123]

with a rom3 card what is the best unlooping unlocker script / program to use

i have a nexus and i havent been able to do it with anything

i just want to know if any1 can share any success stories with certain scripts

man 3rd day already on 1 card what a waiste of freakin time

It will work when you get everything set right. I had the most sucsess with unlockrom3.xvb. Had to get the vcc set right for my loader , it glithed at a slightly higher setting than most run there's at mine I set to 68 high and 5B for low and the delay around 10AF. But like I said every loader vcc is differant. Don't give up, accuratly post what you are doing and you will get good help from here.

[Cid6.7]

take a look @ my rom3 guide..
If yah still need help I'm always here

[mongoose123]

this is my 4th day still no success

[mongoose123]

what is the minimun and the maximum VCC
i tryed from h01 to h99 and got nothing but XXXXXXXXXXXXXXXXXXXXXXXXXX with my orange nexus 911

First off the orange Nexus is very different from one unit to the next. See the zip I posted with info about it in the thread " a little lost" by HillBilly in this glitching forum.
Have you read Cids rom 3 guide and Crazy's modded programmer sticky, in this forum ?
Try different delay settings.
What flash did you use and did it say it took the flash ?
What does reading it in Nagra tell you ?
What switch settings are you using to flash and run program ?
Did you set the new WinEx settings called Loader2 for using mods ?
Did you run VCC analyzer to get your optimal ranges ?
Sorry for asking what may seem insulting questions but without all the info it is hard for anyone here to give informed help.

[Cid6.7]

Is it the new Nexus Duo ..? No mod's needed ...everything is on the board..?
or the T911..?

[mongoose123]

its a ORANGE NEXUS from dishmonkey.com all mods are in the circuitry so no mods needed

[mongoose123]

What flash did you use and did it say it took the flash ?
NewD6
What does reading it in Nagra tell you ?
it reads the card but says the backdoor seems to be closed
i know the backdoor unlock code but it will not unlock
What switch settings are you using to flash and run program ?
1 and 6 to flash 2 and 5 to glitch also tryed 3 to glitch
Did you set the new WinEx settings called Loader2 for using mods ?
i tryed the normal unlooper setting and i tried
the setting in the readme file i downloaded on here
data baud=115200
reset baud=115200
parity =none
rec timout=1000
byte delay=100
reset delay=100
stopbits =1
byte convention= direct
flush echo bytes= no check
flush receive buffer= check

===========================
advanced tab

check device reset(no atr)
no check ignore receive timout
dtr= low
rts= high
toggle line =rts
Did you run VCC analyzer to get your optimal ranges ?
i tried from h01 to hFF and h01 to h99 i did not get anything high is 00 and peak is FF

[Cid6.7]

I got 1 of those Nexus Duo's It was faulty all I could do was flash it..every script I tried to run on it would error out...Sent'er back...

[mongoose123]

ok should i get another nexus or should i get a normal t9100

[Cid6.7]

I'd get the normal T911 & mod it..