[mdeven]

I could, but I want you to try something else for me first....
Get Starglitch Pro.... It runs in WinExplorer....
Run the glitch finder.... It may take a few minutes to finish, but it will give you the best settings for your loader....
If that doesn't work for you, I'll give you what I've got....
Mark

[mdeven]

The number that were generated are the DAC setting that the script found to be best compatible with your loader.... You can just use those one at a time until you find which of the 15 works best.... Starglitch can do anything Extreme can do...only faster (in my case).... Don't get me wrong, I really like Extreme and I think his program rocks and I still use it for some things....
keep us posted....
Mark

[mdeven]

I told you before...use the DAC settings generated by Starglitch.... They will work in ExtremeHU....
If you totally insist after all of that....
DAC1 8E to 72
DAC2 82 Delay 12
INS4C Attempts 5
9 VDC 300mA
I really don't think they'll work as well....
Mark

[ki55tory]

http://pub126.ezboard.com/bdssmilisfriends

Might be a good idea to transfer some of the info over to this board.

ki55tory

[ki55tory]

mhornet:

http://pub126.ezboard.com/fdssmilisf...icID=395.topic

putock
Registered User
Posts: 27
(10/24/02 10:48:39 pm)
Settings: Older AIO w/ dips and installed jumper at JP2
--------------------------------------------------------------------------------
After much experimentation with this unit, I have noticed a significant improvement in the performance and consistency of this older AIO with dips after I modified it by adding my own jumper at JP2. Notice that I am using the same power supply for both loading and unlooping! Hope these settings help a few people. I highly recommend performing this mod if you can manage it. I soldered two pins at the JP2 location and used a computer jumper (one those little square plastic thingies) to short the pins. That way it is easily removable so that the unit can still be flashed at a later date without risking any damage....

UL4S Flash, All dipswitches [OFF], JP2 jumpered

LOADING

Extreme Hu 3.4B Settings:

9V @ 500 mA
DAC 1 MAX 95 MIN 88
DAC 2 90 DELAY 11
INS 48
ATTEMPTS = 4

Use Boot Card option for minimal glitching. Most cards will boot in under 6 attempts using these settings.

UNLOOPING

ExtremeHU Unlooping Alternate #2 - best overall

UL4S original or UL4S Mod4 (can find both scripts in UL4SCombo_v2) - good alternates for tough cards (must use Winexplorer 4.6 or above)

FF or Superloop card (using UL4SCombo_v2) prior to unlooping for best results and use the power supply recommended above at all times.

ki55tory